NEC NEAX 2000 IPS System Manual page 191

A
CM08 Specify Call Transfer from a station before a
called station answers.
When a station that has a C.O./Tie line call (via
TRK-A) on Consultation Hold is talking with
an another C.O./Tie line call (via TRK-B),
specify the system operation after the C.O./Tie
line call (via TRK-B) is completed.
[Series 3300 software required]
END
NOTE: See also the programming for "Trunk to Trunk Connection" in the "Feature Programming
Manual", when no release signal arrives from the incoming trunk route.
Operating Procedure
To transfer a call in progress from a Single-Line Telephone:
1. Press the hookswitch momentarily and receive Feature Dial Tone.
2. Dial the third party and receive ringback tone.
3. Wait for the third party to answer and announce the transfer while keeping the first party on Con-
sultation Hold-All Calls-CCIS. When the station user hangs up, the first and third parties will be
automatically connected.
To transfer a call in progress from a D
1. Press the Transfer key and receive Feature Dial Tone.
2. Dial the third party and receive ringback tone.
3. Wait for the third party to answer and announce the transfer while keeping the first party on Con-
sultation Hold-All Calls-CCIS. When the station user hangs up, the first and third parties will be
automatically connected.
DESCRIPTION
term
:
CHAPTER 3 SYSTEM DATA PROGRAMMING
(1) 062
(2) 0 : Not available
1 : Available
(1) 534
(2) 0 : Return to the original call (via TRK-A)
1 : ROT
– 177 –
CALL TRANSFER-ALL CALLS-CCIS
DATA
NWA-008853-001 Rev.3.0
97ch3002.fm