Message Waiting Lamp Setting-Station-Ccis - NEC NEAX 2000 IPS System Manual
Internet protocol server ccis system manual
Hide thumbs
Also See for NEAX 2000 IPS:
- Command manual (1038 pages) ,
- Installation manual (619 pages) ,
- Reference manual (421 pages)
Table of Contents
Advertisement
MESSAGE WAITING LAMP SETTING-STATION-CCIS
General Description
This feature allows a station user, in the 2400 IPX, to set or cancel a Message Waiting lamp indication,
through the CCIS network, to a station in 2000 IPS with this feature.
Programming
START
CM13
Provide each station with Message Waiting
service.
END
Hardware Required
To provide a Single-Line Telephone with Message Waiting lamp:
• LC (PN-4LCD/4LCF) card
Operating Procedure
To set a Message Waiting indication:
1. Lift the handset and receive dial tone.
2. Dial the Message Waiting feature access code (maximum of three digits) and receive Feature Dial
Tone.
3. Dial the desired station number and receive Service Set Tone.
4. Message Waiting indication is set at the station.
To cancel a Message Waiting indication:
1. Lift the handset and receive dial tone.
2. Dial the Message Waiting cancellation code (maximum of three digits) and receive Feature Dial
Tone.
3. Dial the desired station number and receive Service Set Tone.
4. Message Waiting indication at station is canceled.
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
MESSAGE WAITING LAMP SETTING-STATION-CCIS
•
Y=03
(1)
X-XXXXXXXX: Station No.
(2)
0: To provide
– 292 –
DATA
NWA-008853-001 Rev.3.0
97ch3004.fm
Advertisement
Table of Contents
