NEC NEAX 2000 IPS System Manual page 144

A
CM35 Assign the trunk route data for voice channels.
When you use the ODT card for 2-wire E&M
trunk, set CM35 Y=100 to 14.
NOTE: When using Series 3600 software or later, a reset of the MP card is not required after this
command is set/changed.
When changing the data with online, the data is valid after the trunk card is unplugged and
plugged in.
If the echo occurs when you use the LDT card,
set CM35 Y=100 to 07.
B
DESCRIPTION
INITIAL
INITIAL
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=00
(1) 00-63: Trunk Route No.
(2) 04: Tie Line
• Y=01
(1) 00-63: Trunk Route No.
(2) 7 : DP/DTMF
• Y=04
(1) 00-63: Trunk Route No.
(2) 2: Answer Signal arrives
• Y=05
(1) 00-63: Trunk Route No.
(2) 1 : Release Signal arrives
• Y=09
(1) 00-63: Trunk Route No.
(2) 03: Wink Start/CCIS
• Y=20
(1) 00-63: Trunk Route No.
(2) 00: Wink Start/CCIS
• Y=100
(1) 00-63: Trunk Route No.
(2) 14: 2-wire E&M Trunk
(1) 00-63: Trunk Route No.
(2) 07: LDT (for short line only)
– 130 –
ANALOG CCIS PROGRAMMING
DATA
NWA-008853-001 Rev.3.0
97ch3001.fm
JANUARY/31/2006