ip ospf dead-interval
The ip ospf dead-interval command sets the number of seconds during which the
router hello packets are not seen before the neighboring routers consider the router to
be down. The no ip ospf dead-internal removes the number of seconds set during
which the router hello packets are not seen before the neighboring routers consider the
router to be down.
Group Access
ISP
Command Mode
Interface Configuration
Command Line Usage
ip ospf dead-internal <seconds:1-65535>
no ip ospf dead-internal
Command Syntax
seconds
Command Default
40
integer that specifies the interval, value must
be the same for all routers on the network,
valid values 1 to 65535
OSPF Commands
8-23