BSR 64000 Command Reference Guide
neighbor soft-reconfiguration inbound
The neighbor soft-reconfiguration inbound command starts the storage of incoming
updates without any modification. The no neighbor soft-reconfiguration inbound
command stops this storage and releases the memory used for them.
Use the neighbor soft-reconfiguration inbound command to start update story
required to enable inbound software configuration with the clear ip bgp soft [in]
command. Outbound BGP soft-reconfiguration does not need inbound software
configuration.
Outbound BGP soft-reconfiguration does not need inbound software configuration.
Note: When the neighbor soft-reconfiguration inbound command is
issued, the peer will first be disabled and then enabled again. The no form of
this command doesn't bring the peer down.
Group Access
ISP
Command Mode
Router Configuration
Command Line Usage
neighbor {<A.B.C.D> | <WORD>} soft-reconfiguration inbound
no neighbor {<A.B.C.D> | <WORD>} soft-reconfiguration inbound
Command Syntax
A.B.C.D
WORD
inbound
Command Default
no storage
16-44
neighbor IP address
name of BGP peer group
specific inbound update