BSR 64000 Command Reference Guide
tunnel source
The tunnel source command specifies a source address for a tunnel interface. The no
tunnel source command removes a source address for a tunnel interface.
Group Access
ISP
Command Mode
Interface Configuration (tunnel interface only)
Command Line Usage
tunnel source {<ip-address> | cable <slot>/<interface> | default <slot>/
<interface> | ethernet <slot>/<interface> | gigaether <slot>/<interface> | loopback
<0-16> | pos <slot>/<interface>}
no tunnel source {<ip-address> | cable <slot>/<interface> | default <slot>/
<interface> | ethernet <slot>/<interface> | gigaether <slot>/<interface> | loopback
<0-16> | pos <slot>/<interface>}
Command Syntax
ip-address
cable
default
ethernet / port
gigaether
loopback 0-16
pos
slot
interface
2-76
Source IP address.
Cable interface.
The source interface based on the destination
IP address.
Ethernet interface.
Gigabit Ethernet interface.
Loopback interface.
Packet Over SONET interface.
Module slot number.
Interface number.