BSR 64000 Command Reference Guide
network-clock-select revertive
The network-clock-select revertive command enables revertive mode. The no
network-clock-select revertive command disables revertive mode.
Revertive mode enables the automatic switch-over to the highest priority clock source
available if the current clock goes offline
Note: In order for revertive mode to work properly, you must configure both
the primary and secondary clock sources. If there are no clock sources
configured, the Stratum 3 module on the SRM will remain in free-running
mode.
Group Access
ISP
Command Mode
Global Configuration
Command Line Usage
network-clock-select revertive
no network-clock-select revertive
15-8