Motorola BSR 64000 Reference Manual page 543

Interface Configuration
Command Line Usage
cable upstream [<port>] power-level default [<offset>]
no cable upstream [<port>] power-level default [<offset>]
Command Syntax
port
offset
Command Default
0 dB
Command Example
The following example shows how to use the cable upstream power-level default
command to set the input power level for a 3.2 MHz channel in relative mode from
+11 dBmV to +5 dBmV:
MOT(config-if)# cable upstream 0 power-level default -60
The default input power level is reduced by 6 dB. The power level is now +5 dBmV.
The following example shows how to use the cable upstream power-level default
command to set the input power level for a 3.2 MHz channel in relative mode from
+11 dBmV to 0 dBmV, as shown below:
MOT(config-if)# cable upstream 0 power-level default -110
The default input power level is reduced by 11 dB.
Upstream port number.
The number of dB above or below the default
input power level.
CMTS Commands
13-73