Snmp-Server User - Motorola BSR 64000 Reference Manual

snmp-server user

The snmp-server user command adds a new user to an SNMP group. The no
snmp-server user command removes a user from an SNMP group.
Use the snmp server-user command to configure a remote user. Stipulate the port
number or IP address of the user for the remote SNMP agent.
Note: The user must have a defined password or key before attempting to
use this password or key for authentication. This also holds true for a
localized password. The SNMPv3 agent processes SNMPv3 packets from
the network management station only after authentication.
Group Access
System Administrator
Command Mode
Global Configuration
Command Line Usage
snmp-server user <word> [[auth {sha | md5} {password <password> | key <key> |
local <localized_key>} {password <password> | priv des56} key <key> | local
<localized_key>} [eng-id <engine-id>]]
no snmp-server user <username>
Command Syntax
word
auth
sha
md5
username
authentication parameters for user
uses HMAC/SHA algorithm for
authentication
uses HMAC/MD5 algorithm for
authentication
SNMP Commands
3-37