Cable Upstream Rate-Limit - Motorola BSR 64000 Reference Manual

cable upstream rate-limit

The cable upstream rate-limit command controls whether rate-limiting is applied to
any CM sending upstream data to the CMTS on a given upstream interface.
The no cable upstream rate-limit command changes the rate limit applied to a cable
modem sending upstream data to the CMTS back to the default. The token-bucket
algorithm is used for rate-limiting.
Note: If the rate-limit is enabled, data received from cable modems are
rate-limited according to the cable modems configured. Packets may be
dropped at times when any cable modem, or the hosts behind the cable
modems, transmit data exceeding the permitted bandwidth.
Group Access
MSO
Command Mode
Interface Configuration
Command Line Usage
cable upstream [<port>] rate-limit
no cable upstream [<port>] rate-limit
Command Syntax
port
Command Default
rate-limiting disabled
values 0 to 3
CMTS Commands
13-77