ip dvmrp accept-filter
The ip dvmrp accept-filter command configures a filter for incoming DVMRP
reports. The no ip dvmrp accept-filter command removes configuration of a filter
for incoming DVMRP reports.
Use the ip dvmrp accept-filter command to configure filters to accept and deny
DVMRP routes learned from this interface. The accepted routes are added to the
Multicast Routing Table.
Group Access
ISP
Command Mode
Interface Configuration
Command Line Usage
ip dvmrp accept-filter <1-99>
no ip dvmrp accept-filter <1-99>
Command Syntax
1-99
Command Default
Accepts destination reports from all neighbors.
accept filter number
DVMRP Commands
12-3