Show Clns Neighbors - Motorola BSR 64000 Reference Manual

BSR 64000 Command Reference Guide

show clns neighbors

The show clns neighbors command displays both ES and IS neighbors.
The show clns neighbors command output is all follows:
System ID
SNPA
Interface
State
Init
Up
Holdtime
Type
Protocol
Group Access
All
Command Mode
Privileged EXEC
Command Line Usage
show clns neighbors [cable <X/Y> | ethernet <X/Y> | gigaether <X/Y> | loopback
<1-16> | pos <X/Y> ] [ | ] [begin | exclude | include] [<WORD>]
18-32
System ID of the IS-IS router.
Subnetwork Point of Attachment, which is the data-link layer
address.
Interface in which the system was learned from.
Adjacency state. Up and Init are the states of the ES or IS
neighbor.
System is an IS and is waiting for an IS-IS hello message. IS-IS
regards the neighbor as not adjacent.
Regards the ES or IS as reachable.
The number of seconds before this adjacency entry times out.
The level of the IS-IS router.
The protocol through which the adjacency was learned. Valid
protocol sources are IS-IS, IGRP, or through a static route.