radius-server
The radius-server command configures a RADIUS client to allow communication
with a RADIUS server. Configuring a RADIUS client involves the following tasks:
•
specifying the RADIUS server
•
defining the shared encryption key for authentication between the RADIUS
server and the RADIUS client
•
specifying the number of retry attempts if there is no response from an active
RADIUS server
•
specifying the time interval between retry attempts if there is no response from
from an active RADIUS server
Group Access
System Administrator
Command Mode
Global Configuration
Command Line Usage
radius-server host {<A.B.C.D>|<Hostname>} [auth-port <0-65535> [primary]]
radius-server key <WORD>
radius-server retransmit <0-100>
radius-server timeout <1-1000>
no radius-server host {<A.B.C.D>|<Hostname>} [auth-port <0-65535> [primary]]
no radius-server key <WORD>
no radius-server retransmit <0-100>
no radius-server timeout <1-1000>
Command Syntax
host
A.B.C.D
Hostname
specifies a RADIUS server
the IP address of the RADIUS server
the hostname of the RADIUS server
System Administration Commands
1-51