M320 Host Subsystem Overview; M320 Host Subsystem Description - Juniper M320 Hardware Manual

M320 Router Hardware Guide
Table 5: Performance per SIB/FPC Configuration (continued)
Number of Active
SIBs FPC Type and Number of PICs per FPC
3 FPC1 with up to four PICs
FPC2 with up to four PICs
FPC3 with two PICs
4 FPC1 with up to four PICs
FPC2 with up to four PICs
FPC3 with up to two PICs
Related
Documentation

M320 Host Subsystem Overview

M320 Host Subsystem Description

18
Replacing an M320 SIB on page 172
Maintaining the M320 SIBs on page 121
M320 Host Subsystem Description on page 18
M320 Routing Engine Description on page 19
M320 Routing Engine 600 on page 20
M320 Routing Engine 1600 on page 21
M320 Routing Engine 2000 on page 22
M320 Control Board (CB) Description on page 23
M320 Control Board (CB) LEDs on page 25
The host subsystem provides the routing and system management functions of the
router. You can install one or two host subsystems on the router. To operate, each host
subsystem functions as a unit; the Routing Engine requires the corresponding Control
Board (CB) and vice versa.
NOTE: We recommend that you install two host subsystems for redundant
protection. If you install only one host subsystem, we recommend that you
install it in slot
RE0
Performance
Line rate
Line rate
Line rate not guaranteed
Line rate
Line rate
Line rate
.
Copyright © 2010, Juniper Networks, Inc.