Show Processes Ipc Flow-Control - Dell Force10 Z9000 Reference Manual

Related
show hardware layer2 acl
Commands
stack member port-pipe.
show hardware layer3
stack member port-pipe.
show hardware stack-unit
statistics of the designated component of the designated stack member.
show hardware system-flow
and stack member port-pipe.
show interfaces stack-unit
member.
show processes memory (S-Series)
running in an S-Series.

show processes ipc flow-control

Display the single window protocol queue (SWPQ) statistics.
C-Series, E-Series, S-Series, Z-Series
Syntax show processes ipc flow-control [cp | rp1 | rp2 | lp linecard-
number]
Parameters
cp
rp1
rp2
lp
number
Defaults none
Command Modes
162
– displays Layer 2 ACL data for the selected stack member and
– displays Layer 3 ACL or QoS data for the selected stack member and
– displays the data plane or management plane input and output
– displays Layer 3 ACL or QoS data for the selected stack member
– displays information on all interfaces on a specific S-Series stack
(OPTIONAL) Enter the keyword cp to view the control processor's
SWPQ statistics.
(OPTIONAL) Enter the keyword rp1 to view the control processor's
SWPQ statistics on Route Processor 1.
(OPTIONAL) Enter the keyword rp2 to view the control processor's
SWPQ statistics on Route Processor 2.
linecard-
(OPTIONAL) Enter the keyword lp followed by the line card number
to view the control processor's SWPQ statistics on the specified line
card.
• EXEC
• EXEC Privilege
– displays CPU usage information based on processes
NOTE: Not supported in the S-Series.
NOTE: Not supported in the S-Series.
NOTE: Not supported in the S-Series.