The following is an example of the CLI commands:
console> enable
console# configure
console (config) # logging 10.1.1.1 severity critical
Console# show logging
Logging is enabled.
Console Logging: Level debug. Console Messages: 5 Dropped.
Buffer Logging: Level debug. Buffer Messages: 16 Logged, 16
Displayed, 200 Max.
File Logging: Level error. File Messages: 0 Logged, 209 Dropped.
SysLog server 31.1.1.2 Logging: error. Messages: 22 Dropped.
SysLog server 5.2.2.2 Logging: info. Messages: 0 Dropped.
SysLog server 10.2.2.2 Logging: critical. Messages: 21 Dropped.
SysLog server 10.1.1.1 Logging: critical. Messages: 0 Dropped.
1 messages were not logged
03-Mar-2004 12:02:03 :%LINK-I-Up: g1
03-Mar-2004 12:02:01 :%LINK-W-Down: g2
03-Mar-2004 12:02:01 :%LINK-I-Up: g3
Defining Device IP Addresses
The IP Addressing page contains links for assigning interface and default gateway IP addresses, and
defining ARP and DHCP parameters for the interfaces. To open the IP Addressing page, click System
Addressing in the tree view.
Defining Default Gateways
The Default Gateway page contains fields for assigning Gateway devices. Packets are forwarded to the
default IP when frames are sent to a remote network. The configured IP address must belong to the same IP
address subnet of one of the IP interfaces. To open the Default Gateway page, click System
→
Addressing
Default Gateway in the tree view.
104
Configuring System Information
→
IP
→
IP