Config Ppp Echo Ports - Extreme Networks ExtremeWare Command Reference Manual

config ppp echo ports

config ppp echo [<seconds> <consecutive_misses> | off] ports <portlist>
Description
Configures the link maintenance protocol on the specified ports.
Syntax Description
seconds
consecutive_
misses
off
portlist
Default
The link maintenance protocol is
Usage Guidelines
When link maintenance is enabled and the port is receiving no packets, echo-request packets are
transmitted over the link on a periodic basis. The
that specifies the amount of time between transmissions of echo-request packets. The
consecutive_misses
PPP waits for a reply. If an echo-reply is not received within an interval of duration
(
consecutive_misses
may be disabled using the
Example
The following example enables link maintenance on port 1 of a PoS module in slot 8 and sets
to 3 and
consecutive misses
config ppp echo 3 10 ports 8:1
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies the amount of time in seconds between transmissions of
echo-request packets.
Controls the amount of time that PPP waits for a reply.
Disables the link maintenance protocol.
Specifies the port number(s).
by default.
off
parameter is an integer in the range [1..100] that controls the amount of time that
* ) seconds, the link is brought down. The link maintenance protocol
seconds
keyword.
off
to 10:
parameter in an integer in the range [1..300]
seconds
config ppp echo ports
seconds
1281