Config Route-Map Set Iphost-Routing - Extreme Networks ExtremeWare Command Reference Manual

ARM Commands

config route-map set iphost-routing

config route-map <route-map> <sequence-number> [add | delete ] set
iphost-routing
Description
Enables or disables Selective-LPM for a specified route-map when the LPM feature is enabled.
Syntax Description
route-map
sequence-number
add
delete
Default
N/A.
Usage Guidelines
This command optionally enables or disables Longest Prefix Match (LPM) for the specified route-map.
This command may be used to override the VLAN lpm-routing configuration for specific routes. The
keyword specifies how packets are to be routed for route-map matched IP prefixes.
iphost-routing
If the property is added to a route-map, packets are forwarded to the IP prefixes' next
iphost-routing
hop using the hardware host-based IP FDB. The
learned on VLANs that are lpm-routing enabled.
Example
This command enables Selective-LPM and specifies IP-host routing on the route map lpm_map:
config lpm_map 20 add set iphost-routing
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.8b12.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the BlackDiamond switch only.
1232
Specifies a route map name.
Specifies a sequence number.
Specifies to add the statement to the route map.
Specifies to delete the statement from the route map.
iphost-routing
keyword is only significant for routes
ExtremeWare Software 7.0.0 Command Reference Guide