Config Ports E1 Framing - Extreme Networks ExtremeWare Command Reference Manual

config ports e1 framing

config ports <portlist> e1 framing [crc4 | no-crc4]
Description
Configure framing for E1 links.
Syntax Description
portlist
crc4
no-crc4
Default
CRC4 framing is enabled by default.
Usage Guidelines
Framing is used to synchronize data transmission on the line. Framing allows the hardware to
determine when each packet starts and ends. The two choices for E1 framing are CRC4 and No-CRC4.
Example
The following command sets framing to CRC4 for the E1 ports:
config ports 3:1-3:4 e1 framing crc4
History
This command was first available in ExtremeWare v6.1.8w3.0.1b56 WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
ExtremeWare Software 7.0.0 Command Reference Guide
A list of ports.
Specifies CRC4 framing.
Specifies No-CRC4 framing.
config ports e1 framing
1325