Config Bgp Peer-Group Nlri-Filter - Extreme Networks ExtremeWare Command Reference Manual

BGP Commands

config bgp peer-group nlri-filter

config bgp peer-group <peer group> nlri-filter [in | out] [none | <access
profile>]
Description
Configures the NLRI filter for a peer group and all the neighbors of the peer group.
Syntax Description
peer group
in
out
none
access profile
Default
N/A.
Usage Guidelines
You can use BGP peer groups to group together up to 200 BGP neighbors. All neighbors within the peer
group inherit the parameters of the BGP peer group. The following mandatory parameters are shared
by all neighbors in a peer group:
• remote AS
• source-interface
• out-nlri-filter
• out-aspath-filter
• out-route-map
• send-community
• next-hop-self
Example
The following command configures the NLRI filter for the peer group external and its neighbors using
the access profile nosales:
config bgp peer-group external nlri-filter in nosales
History
This command was available in ExtremeWare 6.1.5.
Platform Availability
This command is available on all "i" series platforms.
1080
Specifies a peer group.
Specifies to install the filter on the input side.
Specifies to install the filter on the output side.
Specifies to remove the filter.
Specifies an access profile.
ExtremeWare Software 7.0.0 Command Reference Guide