Enable Red Ports Queue - Extreme Networks ExtremeWare Command Reference Manual

Version 7.0.0

Hide thumbs Also See for ExtremeWare:

Table of Contents

PoS Commands

enable red ports queue

enable red ports <portlist> queue <queue#>

Enables RED on the specified PoS ports.

Syntax Description

By default, RED is disabled.

Usage Guidelines

keyword has been added to support the PoS module. Currently, this new keyword is only

applicable to PoS ports. The keyword allows the RED function to be selectively enabled on an

individual queue basis. The

omitted, then the command applies to all egress queue numbers for the PoS port(s). (RED is not

supported on the ingress queues.)

The following command enables RED for all PHBs except the EF PHB:

enable red ports 2:1-2:2

This command was modified in an ExtremeWare IP Technology Services Release based on v6.1.5b20 to

support PoS modules.

Platform Availability

The general form of this command is available on the "i" series platforms. The optional queue

parameter is available only on the PoS module on a BlackDiamond switch.

Specifies the port number(s).

Specifies the queue for which the RED function is enabled.

# parameter is an integer in the range [0-7]. If the

ExtremeWare Software 7.0.0 Command Reference Guide

Extremeware 7.0.0