Enable Bgp Neighbor - Extreme Networks ExtremeWare Command Reference Manual

enable bgp neighbor

enable bgp neighbor [<ip address> | all]
Description
Enables the BGP session. The neighbor must be created before the BGP neighbor session can be enabled.
Syntax Description
ip address
all
Default
N/A.
Usage Guidelines
To create a new neighbor and add it to a BGP peer group, use the following command:
create bgp neighbor <ip address> peer-group <peer group> {multi-hop}
The new neighbor is created as part of the peer group and inherits all of the existing parameters of the
peer group. The peer group must have remote AS configured.
To add an existing neighbor to a peer group, use the following command:
config bgp neighbor [<ip address> | all] peer-group <peer group> {acquire-all}
If you do not specify acquire-all, only the mandatory parameters are inherited from the peer group. If
you specify acquire-all, all of the parameters of the peer group are inherited. This command disables the
neighbor before adding it to the peer group.
Example
The following command enables the BGP neighbor session:
enable bgp neighbor 192.168.1.17
History
This command was available in ExtremeWare 6.1.
Platform Availability
This command is available on all "i" series platforms.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies an IP address.
Specifies all neighbors.
enable bgp neighbor
1113