Config Qosprofile - Extreme Networks ExtremeWare Command Reference Manual

PoS Commands

config qosprofile

config qosprofile <qosprofile> {minbw <percent>} {maxbw <percent>}
{priority <level>} {minbuf <percent>} {maxbuf <percent>} {<portlist>}
{egress | ingress}
Description
Configures a QoS profile.
Syntax Description
qosprofile
minbw
maxbw
priority
level
minbuf
maxbuf
portlist
egress
ingress
Default
Normal.
Usage Guidelines
The optional and
egress
keywords are currently only applicable to PoS ports. The PoS modules support eight egress queues and
eight ingress queues per port, and the scheduling parameters for these queues are controlled by QoS
profiles - (in other words, queue #0 is controlled by
qp1 qp8
parameter allows QoS profiles to be customized on a SONET-port basis, while the
portlist
and keywords enable even finer customization (down to a particular
ingress
on a given port). If the
egress
apply to the queue associated with the specified
egress
The parameter is an integer in the range [0..100] that specifies the minimum percentage of the
minbw
bandwidth that must be available for transmissions from the profile. The sum of the
across all eight profiles cannot exceed 90%.
The maxbw parameter is also an integer in the range [1..100] that specifies the maximum percentage of
the bandwidth that can be used for transmissions from the profile. The priority level may be set to low,
lowHi, normal, normalHi, medium, mediumHi, high, or highHi. The priority determines which traffic is
scheduled when bandwidth is still available after the minimum requirements of all profiles have been
satisfied.
1286
Specifies the QoS profile to be configured.
Specifies the minimum percentage of the bandwidth available for
transmissions from the profile.
Specifies the maximum percentage of the bandwidth that can be used for
transmissions from the profile.
Specifies which traffic is scheduled when bandwidth is still available after the
minimum requirements of all profiles have been satisfied.
Specifies the priority level (low, lowHi, normal, normalHi, medium, mediumHi,
high, or highHi).
This keyword is not applicable to SONET ports.
This keyword is not applicable to SONET ports.
Specifies the port number(s).
Specifies that the flow is from the SONET port.
Specifies that the flow is to the SONET port.
keywords have been added to support the PoS module. These new
ingress
and keywords are omitted, then the configured parameters
ingress
, queue #1 by , and so on). The
qp1 qp2
egress
.
qosprofile
ExtremeWare Software 7.0.0 Command Reference Guide
egress
or queue
ingress
parameters
minbw