Unconfig Aps - Extreme Networks ExtremeWare Command Reference Manual

unconfig aps

unconfig aps
unconfig aps <group#>
Description
Resets the APS group configuration parameters to their default values.
Syntax Description
group# Specifies the APS group# to which the command applies.
Default
N/A.
Usage Guidelines
You specify the parameter, which is an integer in the range [1-65535]. The identifies the
group# group#
APS group that the command applies to. The command does not affect the ports that have been added
to the APS group. The command does cancel any outstanding lockout, force, or manual switch requests.
Example
The following command example resets the configuration parameters of APS group to their
1001
default values:
unconfig aps 1001
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.
ExtremeWare Software 7.0.0 Command Reference Guide 1315