Config Ppp User - Extreme Networks ExtremeWare Command Reference Manual

T1, E1, and T3 WAN Commands

config ppp user

config ppp user <name> {encrypted} {<password>} [ports <portlist> |
multilink <groupname>]
Description
Configures the user
name
authentication.
Syntax Description
name
encrypted
password
portlist
groupname
Default
By default, there is no value set for name or password.
Usage Guidelines
The is also sent when a port transmits a CHAP authentication request. The implementation
name
responds to either CHAP or PAP authentication requests issued by the peer regardless of whether the
port is configured to authenticate the peer. The
[1..32] characters. The
password
characters. If no
password
password twice (with the second time serving as a confirmation). You should not enter the encrypted
parameter option (it is used by the switch when generating an ASCII configuration).
Example
The following command example sets the name to
multilink group
m_link1
config ppp user "titus" "1Afortune" multilink m_link1
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed. A
similar command is available on the BlackDiamond switch.
1340
and that the specified PPP/MLPPP link uses if the peer requests
password
Specifies user name for PPP peer authentication requests.
This parameter option should not be entered.
Specifies the password for PPP peer authentication requests.
Specifies the port number(s).
Specifies a previously created multilink group
name
parameter is also a character string, with a maximum length of 32
is provided on the command line, then you are prompted to enter the
:
parameter is a string with a length in the range of
and sets the password to
titus
for the
1Afortune
ExtremeWare Software 7.0.0 Command Reference Guide