Synchronize - Extreme Networks ExtremeWare Command Reference Manual

Version 7.0.0

Hide thumbs Also See for ExtremeWare:

Table of Contents

Configuration and Image Commands

synchronize

Replicates all saved images and configurations from the master MSM to the slave MSM on the

BlackDiamond.

Syntax Description

This command has no arguments or variables.

Usage Guidelines

This command does the following:

1 Copy both the primary and secondary software images

2 Copy both the primary and secondary configurations

3 Copy the BootROM

4 Reboot the slave MSM64i

When you hot add a slave MSM64i, the slave will automatically do a sync to bring the master's

configurations over to the slave. However, if one of the configurations on the master MSM is empty, the

sync process will not overwrite the corresponding configuration on the slave. If the configuration on the

slave MSM64i is an older configuration, this can cause problems if the switch is rebooted using the

outdated configuration.

This command does not replicate the run-time configuration. You must use the

command to store

the run-time configuration first.

The following command replicates all saved images and configurations from the master MSM64i to the

slave MSM64i:

This command was first available in ExtremeWare 4.0.

Platform Availability

This command is available on the BlackDiamond switch.

ExtremeWare Software 7.0.0 Command Reference Guide

Extremeware 7.0.0