Config Route-Map Set Lpm-Routing - Extreme Networks ExtremeWare Command Reference Manual

Version 7.0.0

Hide thumbs Also See for ExtremeWare:

Table of Contents

config route-map set lpm-routing

config route-map <route-map> <sequence-number> [add | delete ] set

Enables or disables Selective-LPM for a specified route-map when the LPM feature is enabled.

Syntax Description

sequence-number

Usage Guidelines

This command optionally enables or disables Longest Prefix Match (LPM) for the specified route-map.

This command may be used to override the VLAN lpm-routing configuration for specific routes. The

the ARM/MPLS module using LPM routing.

This command enables Selective-LPM and specifies lpm-routing on the route map lpm_map:

config lpm_map 10 add set lpm-routing

This command was first available in an ExtremeWare IP Technology Services Release based on

This command was subsequently incorporated into ExtremeWare 7.0.0.

Platform Availability

This command is available on the BlackDiamond switch only.

ExtremeWare Software 7.0.0 Command Reference Guide

Specifies a route map name.

Specifies a sequence number.

Specifies to add the statement to the route map.

Specifies to delete the statement from the route map.

keyword specifies how packets are to be routed for route-map matched IP prefixes. If the

property is added to a route-map, packets are forwarded to the IP prefixes' next hop by

keyword is only significant for routes learned on VLANs that are not lpm-routing

config route-map set lpm-routing

Extremeware 7.0.0