IP Multicast Commands
config igmp snooping leave-timeout
config igmp snooping leave-timeout <leave_time ms>
Description
Configures the IGMP snooping leave timeout.
Syntax Description
leave_time ms
Specifies an IGMP leave timeout value in milliseconds.
Default
1000 ms.
Usage Guidelines
The range is 0 - 10000 ms (10 seconds). For timeout values of one second or less, you must set the
leave-timeout to a multiple of 100 ms. For values of more than one second, you must set the
leave-timout to a multiple of 1000 ms (one second).
The specified time is the maximum leave timeout value. The switch could leave sooner if an IGMP
leave message is received before the timeout occurs.
Example
The following command configures the IGMP snooping leave timeout:
config igmp snooping leave-timeout 10000
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on "i" series platforms.
1140
ExtremeWare Software 7.0.0 Command Reference Guide