Config Aps Delete - Extreme Networks ExtremeWare Command Reference Manual

Version 7.0.0

Hide thumbs Also See for ExtremeWare:

Table of Contents

PoS Commands

config aps delete

config aps <group#> delete <port>

Deletes a SONET port from an APS group.

Syntax Description

Usage Guidelines

You specify the

parameter, which is an integer in the range [1-65535]. The

APS group that the port is to be deleted from. You also specify the

SONET port that is to be deleted from the APS group. If you delete the working line from a group, it

causes a switch to the protection line; however, if you delete an active protection line from a group, it

does not initiate a switch to the working line.

The following command example deletes port 1 of the module installed in slot 8 of the BlackDiamond

switch from APS group 1001:

config aps 1001 delete 8:1

This command was first available in an ExtremeWare IP Technology Services Release based on

Platform Availability

This command is available on the BlackDiamond switch only.

Specifies the APS group# to which the command applies.

Specifies the port number.

identifies the

parameter, which identifies the

ExtremeWare Software 7.0.0 Command Reference Guide

Extremeware 7.0.0