Config Ipxroute Add - Extreme Networks ExtremeWare Command Reference Manual

config ipxroute add

config ipxroute add [<dest_netid> | default] <next_hop_id>
<next_hop_node_addr> <hops> <tics>
Description
Adds a static IPX route entry in the IPX route table.
Syntax Description
dest_netid
next_hop_id
next_hop_node_addr
hops
tics
Default
N/A.
Usage Guidelines
Static routes are used to reach networks not advertised by routers. You can configure up to 64 static IPX
routes on the switch. Static routes are never aged out of the routing table. Static routes are advertised to
the network using IPX/RIP.
Example
The following command adds a static IPX route entry to the IPX route table:
config ipxroute add default 0011 00:eb:2a:0b:1e:0a
History
This command was introduced in ExtremeWare 4.0.
Platform Availability
This command is available on the all "i" series systems.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies the destination NetID.
Specifies the NetID of the neighbor IPX network.
Specifies the node address of the next IPX router.
Specifies the maximum hop count.
Specifies the timer delay value.
config ipxroute add
1193