Direct Extension Dial Delay (#112) - Avaya PARTNER Advanced Communications System Installation And Use Manual

To turn Direct Extension Dial off, press the Direct Extension Dial Button at extension 10. The
green light goes off and Direct Extension Dial is off. Any calls being answered by the system
continue to hear the recorded message and are prompted to enter a destination extension.

Direct Extension Dial Delay (#112)

Use this feature to specify the number of times (0–9) an incoming call should ring before it is
answered by the Direct Extension Dial feature.
Considerations
This feature works independently of Line Ringing, which determines how an outside call rings
at the extension—immediately, after a 20 second delay, or not at all. Direct Extension Dial
Delay specifies the number of rings a caller hears before the system answers the call.
If you use Caller ID, make sure Direct Extension Dial Delay is set to 2 rings or more to
ensure that Caller ID information is captured.
If you use T1 lines with Direct Inward Dialing (DID) that are not administered for Direct
Inward Dialing (DID) in PARTNER ACS R6.0 PC Administration, set the number of rings to 1
ring or more.
Programming
To change the number of times an incoming call rings at extension 10 before the system answers
it:
f00ss#112
1. Press
2. To change the number of rings, press
range from 0 to 9, where 0 means the call is answered immediately. The factory setting is 2.
3. Select another procedure, or exit programming mode.
7
7
7
.
D
until the appropriate value appears. Values
Operator Features
Direct Extension Dial Features
7-13