Avaya PARTNER Advanced Communications System Installation And Use Manual page 54

®
PARTNER Advanced Communications System Installation, Programming, and Use
c. From the Expected Number of Digits box, choose the number of digits the PARTNER
system will receive from the T1 service provider.
d. Perform either of the following steps:
— If you want to automatically assign a consecutive range of DID numbers to a range of
extensions/hunt groups/calling groups:
a. From the Last box in the Automatic Numbering area, choose the last item number
on this page you want to map.
b. From the First box, choose the first item number on this page you want to map.
c. In the DID No. box, enter the first DID number you want to map. For example, if
you have the DID numbers 100 through 109, you would enter 100.
d. From the Ext./Grp box, select the first extension you want to map to the first DID
number.
e. Click the Update button.
The Item No. you specified in the First box is assigned the DID number you
specified in the DID No. box, and the extension, hunt group, or calling group you
specified in the Ext./Grp box is mapped to that DID number. The next Item No. is
assigned to the next DID number in the range, and the next extension, hunt
group, or calling group is mapped to that DID number. Each Item No. in the range
you specified is mapped to next DID number and extension, hunt group, calling
group.
— If you want to manually assign a range of DID numbers to a range of extensions/hunt
groups/calling groups:
a. In the first DID No. box, enter a DID number. (You can only enter each DID
number once in the DID Mapping Table.)
b. From the corresponding Extension/Hunt/Call Group box, select the extension,
hunt group, or calling group you want to "map" to the DID number. (You can map
an extension, hunt group, or calling group to multiple DID numbers.)
c. Repeat Steps a and b for each DID number.
e. From the DID Backup Destination box, select the backup extension that will receive DID
calls that do not match any of the entries in the DID Mapping Table.
9. Program the other features (such as extension features and restrictions) you want. (See the
procedures in "Program PARTNER Features in a PC Administration File" in the online help.)
10. Save the file. Select Save from the File menu to save your changes to the file.
11. Program the settings in this file to the PARTNER system.
a. Make sure you are connected to the PARTNER system.
b. From the Administration menu, select Send System Information.
The Open dialog box appears.
The T1 Module
2-22