Using A Pc Card - Avaya PARTNER Advanced Communications System Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use
Change the batteries in the processor module every year, even if the system has not yet displayed
the ReplaceSysBat W/Power On message. Choose good quality alkaline batteries. (See
"Inserting Batteries in the Processor Module" on page

Using a PC Card

Follow these steps to upgrade your system's software with a PC card:
In Release 4.0 systems, using a PC card does not upgrade the configuration of the 1600
DSL module. This configuration is retained in the flash memory of the 1600 DSL module,
not on the PC card. When the system resets, the configuration in the flash memory of the
1600 DSL module becomes the active configuration for that module.
In Release 4.0 and later systems, a firmware upgrade can be performed on the 1600 DSL
module by using a Remote Access PC Card or a Backup/Restore PC Card that is
configured for the firmware upgrade. See
Firmware" on page 10-7
In Release 5.0 and later systems, a firmware upgrade can be performed on the 012E
module by using a Remote Access PC Card or a Backup/Restore PC Card that is
configured for the firmware upgrade. See
Firmware" on page 10-7
In Release 6.0 or later systems, a firmware upgrade can be performed on the T1 module.
CAUTION:
Before starting, verify that you have batteries installed in the processor module by viewing
the display of the telephone at extension 10.

Using a PC Card

10-2
2-11.)
"Upgrading 1600 DSL and 012E Module
for more information.
"Upgrading 1600 DSL and 012E Module
for more information.
1 0