Caller Id Features; Programming - Avaya PARTNER Advanced Communications System Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use
You cannot screen a call if the Cell Phone Connect feature is active.

Programming

f00ssc
1. Press
2. Enter the number of the extension to be programmed with the feature.
3. Press a programmable button with LEDs.
f25
4. Press
5. Program another extension, or exit programming mode.

Caller ID Features

Caller ID is available on system display telephones on all lines for which you subscribe to Caller
ID service. Caller ID information is the caller's telephone number (and name, if available). When
active on a call, you automatically receive Caller ID information for the duration of the call. When
your extension is idle, you receive Caller ID information for the call you will be connected to when
you lift the handset.
In Release 4.0 and later systems, you receive both the caller's number and name on a
two-line display telephone while the call is ringing. The TransTalk telephones only receive
either the caller's number or the caller's name, depending on the status of the Caller ID
Name Display feature.
The following Caller ID features can be implemented by individual telephone users:
Caller ID Inspect
Caller ID Call Logging and Dialing
Caller ID Name Display
You can use all these features while using Call Screening (F25).
Caller ID information is unavailable on T1 lines. The message "Direct In Dial" or "DID" is
displayed for incoming calls on T1 lines with Direct Inward Dialing (DID).

Caller ID Features

8-18
.
8
at extension 10 or 11.
8