Initializing The System - Avaya PARTNER Advanced Communications System Installation And Use Manual

5. With the locking latch in the unlocked position
(battery icon and "minus" icon visible), slide the
battery assembly into the processor module
along the battery guides on the inside of the
battery compartment (see
the battery assembly in far enough that the
edges of the assembly slip behind the plastic
housing of the processor module.
6. Pressing lightly on the battery icon on the front of the battery assembly, slide the locking
latch downward to secure the assembly in place. The "plus" icon and the battery icon should
now be visible on the front of the battery assembly (see

Initializing the System

To initialize the system, you MUST insert the enclosed PC Card before powering up the
system for the first time. You may also insert any one of the additional supported PC Cards:
Backup/Restore card, Automatic System Answer/Direct Extension Dial (ASA/DXD) card,
PARTNER Voice Messaging Basics card, and PARTNER Remote Access PC Card (Release
3.0 and later systems).
You must power down the system before you insert or remove a PC Card.
Follow these steps to initialize a system:
1. If your PC Card comes with a write-protect tab, verify that the write-protect tab on the PC
Card is not in the write-protected position. If it is, use a paperclip or another pointed object
to push the write-protect tab on the end of the PC Card upward to the nonprotected
position.
2. To insert the PC Card, hold it with the label facing to the right, and slide it gently into one of
the PC Card slots on the processor module. When inserted properly, the PC Card projects
about 1-5/8" (4 cm) from the module.
3. If you have a 5-slot carrier, make sure the carrier's On/Off switch is at the Off ("O") position.
Figure 2-15). Push
Tab
Figure 2-15. Sliding the Battery
Assembly into the
Processor Module
Figure 2-13).
2
Installing the Control Unit
Installation
Locking Latch
2-13