®
PARTNER
Advanced Communications System Installation, Programming, and Use
Installing the Control Unit
The stand-alone processor module or a carrier and its modules are referred to as the control unit.
The control unit must always be wall-mounted.
Before installing the system, be sure you read the safety instructions in the front of this
guide.
WARNING:
There are no customer-serviceable components inside the system modules or carrier. There
are hazardous voltages within that can cause severe or fatal personal injury. DO NOT OPEN
MODULES.
To install the control unit, you must do the following:
Wall-mount the control unit.
Label the jacks.
Ground the system.
Insert the batteries into the processor module.
Initialize the system.
Check the LEDs on the modules.
Wall-Mounting the Control Unit
The PARTNER Advanced Communications System can be installed in one of three
configurations:
Stand-alone PARTNER ACS processor module
2-Slot Carrier, which can hold up to two modules
5-Slot Carrier, which can hold up to five modules
Installing the Control Unit
2-4
2
2