Replacing Modules In A 5-Slot Carrier - Avaya PARTNER Advanced Communications System Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use
8. Remove the screw at the top of the processor module, and remove the module from the wall
(see Figure 10-10).
Figure 10-10. Removing the Top Screw
9. Mount the new PARTNER ACS processor module by following the instructions in
Mounting a Stand-Alone Processor Module and a 2-Slot Carrier" on page 2-5
Batteries in the Processor Module" on page 2-11
10. Mount or remount the top module by following the steps in
Processor Module and a 2-Slot Carrier" on page
11. Connect the line and extension cords one at a time, making sure to place the correct cords
into their corresponding jacks on the new module. (See
page 2-16.)
12. Reconnect the power cord.
CAUTION:
The power cord should hang straight down from the connector, flush against the plastic
case. Do not install the power cord at an angle to the case or with a loop in it.

Replacing Modules in a 5-Slot Carrier

Replacing a module in a 5-slot carrier involves many of the steps used in installing the modules.
CAUTION:
Before starting, verify that you have batteries installed in the processor module by viewing
the display of the telephone at extension 10.
Replacing Modules
10-14
earlier in this guide.
"Wall-Mounting a Stand-Alone
2-5.
"Connecting Lines and Extensions" on
1 0
"Wall-
and "Inserting