Display Shows "Restore Failed - Try Again" For Two Seconds In System Programming Mode; System Programming Settings Reverted To Default Settings; Display Shows "Restore Complete," But All Calls Were Disconnected - Avaya PARTNER Advanced Communications System Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use
Display Shows "Restore Failed – Try Again" for
Two Seconds in System Programming Mode
This display indicates that all system and telephone programming has reverted to the
default settings.
Possible Cause 1: The Backup/Restore PC Card was removed while the restore was in progress.
What to do: Check to see whether the PC Card was removed. If it was not, go to Possible Cause
2. If it was, power down the system, reinsert the Backup/Restore PC Card, reapply power to the
system, and restart the Restore Programming (#125) procedure.
Possible Cause 2: The backup file is corrupted.
What to do: Retry the Restore Programming (#125) procedure. If you get the same result, try
again by using a different backup file from the same Backup/Restore PC Card or a file from a
different Backup/Restore PC Card. Remember to power down the system before you insert or
remove Backup/Restore PC Cards.
System Programming Settings
Reverted to Default Settings
Possible Cause: You ran the Restore Programming (#125) procedure, but the restore failed.
What to do: See Possible Causes 1 and 2 under
Two Seconds in System Programming
Display Shows "Restore Complete,"
but All Calls Were Disconnected
Possible Cause: You just ran the Restore Programming (#125) procedure.
What to do: Nothing. This is normal behavior after a restore; the system resets itself. In the future,
warn users before beginning the restore, or perform the restore during nonbusiness hours.
Problems with System Restore
11-26
1 1
1 1
"Display Shows "Restore Failed – Try Again" for
Mode."
1 1