Avaya PARTNER Advanced Communications System Installation And Use Manual page 370

®
PARTNER Advanced Communications System Installation, Programming, and Use
4. To insert the PC Card, hold it with the label facing to the right and slide it gently into either PC
Card slot on the processor module (see
projects about 1-5/8 inch (4 cm) from the module.
Figure 10-2. Inserting the PC Card
5. Power up the system:
a. Reconnect the power cord.
CAUTION:
The power cord should hang straight down from the connector, flush against the
plastic case. Do not install the power cord at an angle to the case or with a loop in it.
b. If you have a 5-slot carrier, move the carrier's On/Off switch to the "On" position ("—").
While the system upgrades, the LED on the processor module flashes green and red
alternately. When the upgrade has finished (in about 20 to 40 seconds), the LED becomes
steady green.
If the system has a T1 module, the module itself may take up to one minute to initialize.
If the system has a 1600 DSL module, the module itself may take from 2 to 7 minutes
to initialize.
6. Check that all green lights on the fronts of the modules are lit:
If a single light is out, power down the control unit, reseat the module and power up the
control unit.
If multiple lights are out, power down the control unit, reseat the leftmost module that has
a light out, and power up the control unit.
If the lights are still out, call for support as instructed on the inside front cover of this guide.
Using a PC Card
10-4
Figure 10-2). When inserted properly, the PC Card
FT
L
I
N
E
S
206
MODULE
FT
L
FT I
N
E
S
E
X
T
E
N
S
I
O
N
206
S
MODULE