Avaya PARTNER Advanced Communications System Installation And Use Manual page 302

®
PARTNER Advanced Communications System Installation, Programming, and Use
Considerations
If the system is connected to a PBX or Centrex system and a dial-out code (usually 9) is
needed to place calls outside the PBX or Centrex system, include the dial-out code in Speed
Dial numbers that must dial out of the PBX or Centrex system.
You cannot program Personal Speed Dial numbers onto Auto Dial buttons.
You can dial Personal Speed Dial numbers on a single-line telephone, but the numbers must
be programmed from extension 10 or 11.
A combined total of 800 outside Auto Dial and Personal Speed Dial numbers can be
programmed.
You can store account codes as Personal Speed Dial numbers for use with the Account
Code Entry feature.
External Hotline (#311) uses Personal Speed Dial code 80 for the External Hotline
telephone number.
A Personal Speed Dial number can begin with a star code; the system automatically inserts a
delay based on the Star Code Dial Delay setting.
Personal Speed Dial cannot be used with Call Screening (F25).
Cell Phone Connect and Remote Call Forwarding require Personal Speed Dial numbers
for the destination telephone number. Do not use the special dialing functions when entering a
Personal Speed Dial number for these features.
You can program Personal Speed Dial numbers when the Station Lock feature is used.
Programming
To program Personal Speed Dial numbers:
f00
1. Press
2. Select a two-digit code by pressing
If a number is assigned already to the code, the number appears on the display. If no number
is assigned to the code, the display reads Blank.
3. Enter the telephone number exactly as you would dial it. The number can be up to 28
characters consisting of the digits 0–9,
access by pressing
Enable).
4. Do one of the following:
To program another Personal Speed Dial number, start from Step 2.
To program over an existing number, enter the new number after selecting the two-digit
code.
To remove a Personal Speed Dial number, enter the number's two-digit code and press
!
once.
5. Continue programming, or exit programming mode.
Speed Dialing Features
8-64
.
f
*
h !
(Pause),
8
8
and dialing two digits between 80 and 99.
#
, , and special dialing functions that you can
S
(Stop), (Recall), and
&
(Touch-Tone