Display Shows "Backup Failed:check Card" In System Programming Mode; Display Shows "Backup Failed:systembusy" In System Programming Mode - Avaya PARTNER Advanced Communications System Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use
Display Shows "Backup Failed:Check Card"
in System Programming Mode
Possible Cause 1: The Backup/Restore PC Card was removed while the backup was in progress.
What to do: Check to see whether the PC Card was removed. If it was not, go to Possible Cause
2. If it was, power down the system, reinsert the PC Card, and reapply power to the system.
Restart the Backup Programming—Manual (#124) procedure.
Possible Cause 2: The Backup/Restore PC Card or the PARTNER ACS processor module is
corrupted.
What to do: Try the backup again using the backup procedure—Backup Programming—Manual
(#124).
If the backup completes successfully, the problem is solved.
If the backup fails again, try to determine whether the problem is a corrupted PC Card or a
corrupted processor module by trying the backup twice using two different Backup/Restore PC
Cards:
— If the system will not write to either PC Card, the processor module is probably corrupted;
call the helpline number listed on the front, inside cover.
— If the system writes to one of the PC Cards, the original PC Card is corrupted. See
"Obtaining Products" in the PARTNER Customer Support document to order a new
Backup/Restore PC Card.
Display Shows "Backup Failed:SystemBusy"
in System Programming Mode
Possible Cause: Changes were being made to system programming or central telephone
programming while a backup was in progress.
What to do: Try Backup Programming—Manual (#124) later when the system is idle or during
nonbusiness hours.
Problems with Manual Backup
11-24
1 1
1 1