3Com 3C13636 Configuration Manual page 310

3Com Router 3000 Ethernet Family
Configuration Guide
Note:
If the ppp mp binding-mode authentication command is configured to enable
the router to perform MP bundling according to authenticated username, you are
recommended to configure PPP PAP or CHAP authentication on physical
subchannels. Otherwise, all users are regarded anonymous and their
corresponding subchannels are assigned to a default bundle. As this bundle has
no name, its information is not available when the display ppp mp command is
performed.
After configuring the
interface, shut down all its physical subchannels and then undo the operation to
have the command take effect.
IV. Configuring maximum/minimum number of mp bundled links (optional)
Execute the ppp mp max-bind command in virtual-template view or dialer interface
view. Execute the ppp mp min-bind command in dialer interface view.
Table 1-23 Configure maximum/minimum number of MP bundled links
Configure maximum number of MP
bundled links
Restore the default configuration
Configure minimum number of MP
bundled links
Restore the default configuration
By default, the maximum number of bundled links is 16 and the minimum number is 1.
min-bind-num must be less than max-bind-num.
ppp mp binding-mode
Operation
3Com Corporation
1-18
Chapter 1 PPP and MP Configuration
command on a virtual template
Command
ppp mp max-bind max-bind-num
undo ppp mp max-bind
ppp mp min-bind min-bind-num
undo ppp mp min-bind