Default Settings - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Example 45-6 Displays IPv4 Statistics
switch# show ips stats ip interface gigabitethernet 4/1
Internet Protocol Statistics for port GigabitEthernet4/1
Default Settings
Table 45-2
Table 45-2
Parameters
IPv4 MTU frame size
Autonegotiation
Promiscuous mode
Cisco MDS 9000 Family CLI Configuration Guide
45-10
168 total received, 168 good, 0 error
0 reassembly required, 0 reassembled ok, 0 dropped after timeout
371 packets sent, 0 outgoing dropped, 0 dropped no route
0 fragments created, 0 cannot fragment
lists the default settings for IPv4 parameters.
Default IPv4 Parameters
Chapter 45 Configuring IPv4 for Gigabit Ethernet Interfaces
Default
1500 bytes for all Ethernet ports.
Enabled.
Disabled.
OL-16184-01, Cisco MDS SAN-OS Release 3.x