Removing Appliance-Generated Entities; Removing Avts And Avt Luns; Removing Santap Sessions; Removing Initiator-Target-Luns - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Removing Appliance-Generated Entities

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Removing Appliance-Generated Entities
An appliance might terminate its SANTap application without removing generated entities on the MDS
switch. This section describes how to remove these entities using the CLI on the MDS switch.
This section includes the following topics:
•
•
•

Removing AVTs and AVT LUNs

Occasionally the AVT and AVT LUN configuration remains after a SANTap application terminates. To
remove AVTs and AVT LUNs, follow these steps:
Command
Step 1
switch# show santap module 2 avt
switch# show santap module 2 avtlun
Step 2
switch# clear santap module 2 avt
2a:4b:00:05:30:00:22:25 lun 0x0
switch# clear santap module 2 avt
2a:4b:00:05:30:00:22:25

Removing SANTap Sessions

Occasionally a SANTap session continues after a SANTap application terminates. To remove a SANTap
session, follow these steps:
Command
Step 1
switch# show santap module 2 session
Step 2
switch# clear santap module 2 session 1

Removing Initiator-Target-LUNs

The initiator-target-LUN (ITL) triplet identifies a LUN loaded on a DVT. Occasionally the ITL
configuration remains after a SANTap application terminates. To remove all LUNs for an ITL triplet,
follow these steps:
Command
Step 1
switch# show santap module 2 dvtlun
Step 2
switch# clear santap module 2 itl
target-pwwn 22:00:00:20:37:88:20:ef
host-pwwn 22:00:00:20:37:88:20:ef
Cisco MDS 9000 Family CLI Configuration Guide
49-8
Removing AVTs and AVT LUNs, page 49-8
Removing SANTap Sessions, page 49-8
Removing Initiator-Target-LUNs, page 49-8
Chapter 49
Purpose
Displays the AVT pWWNs.
Displays the AVT pWWNs and LUNs
Removes a LUN from the AVT.
Removes the AVT.
You can remove the AVT only after all
Note
the LUNs are removed.
Purpose
Displays SANTap session information on the
SSM in slot 2.
Removes SANTap session 1 on the SSM in slot 2.
Purpose
Displays the target and host pWWNs for the ITLs
on the SSM in slot 2.
Removes an IT L on the SSM in slot 2.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Configuring SANTap