Table of Contents
Advertisement
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
show ip route entry
This command displays detailed information about the route to a specific network to be displayed.
The value for <networkaddr> is a valid IP address.
Format
Mode
Network Address
Subnet Mask
Protocol
Next Hop Interface
Next Hop IP Address
Metric
show ip route preferences
This command displays detailed information about the route preferences. Route preferences are
used in determining the best route. Lower router preference values are preferred over higher router
preference values.
Format
Mode
Local
Static
OSPF Intra
OSPF Inter
OSPF Type-1
OSPF Type-2
RIP
BGP4
Routing Commands
show ip route entry <networkaddr>
Privileged EXEC and User EXEC
Is a valid network address identifying the network on the speci-
fied interface.
Is a mask of the network and host portion of the IP address for the
attached network.
Tells which protocol added the specified route. The possibilities
are: local, static, OSPF or RIP.
The outgoing router interface to use when forwarding traffic to
the next destination.
The outgoing router IP address to use when forwarding traffic to
the next router (if any) in the path toward the destination.
The metric value that is used for this route entry.
show ip route preferences
Privileged EXEC and User EXEC
This field displays the local route preference value.
This field displays the static route preference value.
This field displays the OSPF Intra route preference value.
This field displays the OSPF Inter route preference value.
This field displays the OSPF Type-1 route preference value.
This field displays the OSPF Type-2 route preference value.
This field displays the RIP route preference value.
This field displays the BGP-4 route preference value.
202-10009-01_060204
9-51
Advertisement
Table of Contents
