Show Ip Route Preferences - NETGEAR ProSafe GSM7228PS Cli Manual

Term Definition
Reject Routes Total number of reject routes installed by all protocols.
Total Routes Total number of routes in the routing table.
The following shows example CLI display output for the command.
(Switch) #show ip route summary
Connected Routes..............................1
Static Routes.................................7
RIP Routes....................................0
BGP Routes....................................0
OSPF Routes...................................0
Intra Area Routes...........................0
Inter Area Routes...........................0
External Type-1 Routes......................0
External Type-2 Routes......................0
Reject Routes.................................2
Total routes..................................8

show ip route preferences

This command displays detailed information about the route preferences. Route preferences are
used in determining the best route. Lower router preference values are preferred over higher router
preference values. A route with a preference of 255 cannot be used to forward traffic.
Format
show ip route preferences
Modes • Privileged EXEC
• User EXEC
Term Definition
Local The local route preference value.
Static The static route preference value.
OSPF Intra The OSPF Intra route preference value.
OSPF Inter The OSPF Inter route preference value.
OSPF External The OSPF External route preference value.
RIP The RIP route preference value.
Routing Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
4-19