Assign An Ip Address To The Default Group - Alcatel OmniSwitch/Router Getting Started Manual

Omniswitch/router
Hide thumbs Also See for OmniSwitch/Router:
Table of Contents

Advertisement

i.
The
aging timer indicates how many
MAC
seconds any duplicate
switch's
(Content Addressable Memory) if
CAM
there is no traffic from those
specified time has expired, inactive
out of the
. To view the switch's
CAM
timer value (default=
at the
prompt and press
CLI
timer
shown in the example below:
-> system dup-mac-timer
0
j.
To specify the switch's
seconds, type
system dup-mac-timer
number of seconds (the valid range is
through
1000000
press
. For example, to specify
<Enter>
the
aging timer value, type the following at
MAC
the
prompt and press
CLI
-> system dup-mac-timer 5000
o Important Notes o
Do not use commas when specifying a
aging timer value. For example,
MAC
the entry
63,000
If you want to use the Group aging
timer, enter
as the value for the
0
aging timer.
No confirmation message will appear
onscreen. To verify that the switch's
aging timer has been set, type
MAC
system dup-mac-timer
and press
<Enter>
14 Installing Your Switch
s can remain in the
MAC
s. After the
MAC
MAC
MAC
), type
0
system dup-mac-
<Enter>
aging timer value in
MAC
followed by a
10
seconds) at the
prompt and
CLI
5000
:
<Enter>
will result in an error.
MAC
at the
prompt
CLI
.

13. Assign an IP Address to the Default Group

All switches are configured with a default Group and
. You can add Groups and
VLAN
s age
the switch software. To get started, you can use the
aging
default group and default
address for this switch. (The default
, as
192.168.10.1
complete the following steps:
a. To assign or modify the default Group and
Address, type the following at the
and press
-> group 1 router ip
where
< ip-address >
as
virtual router port (for example,
b. No confirmation message will appear onscreen.
Only the system prompt (
See your switch manual to set other parameters.
VLAN
to configure the
VLAN
.) To modify Group
routing parameters,
IP
:
<Enter>
<
ip-address
is the default group and VLAN, and
1
is the
Address for a specific
IP
) will appear.
->
s later through
IP
address is
IP
VLAN
prompt
CLI
>
).
168.23.9.100

Advertisement

Table of Contents
loading

Table of Contents