Changing The Username And Password For Command Line Access - Nortel Observe User Manual

Nortel Proprietary
3.4 Changing the username and password for
command line access
It is strongly recommended that the logon password and username for command
line access are changed from their default values by using the command
shellPasswordSet. (Defaults are "raoadmin" for username, "raosecurity" for
password)
The username and password must both be between eight and ten characters long:
> shellPasswordSet
Enter current username: username1
Enter current password: password1
Enter new username: username2
Enter new password: password2
Enter new password again to confirm: password2:
value = 0
>
If a non-zero "value" is returned, the password and username have not been
changed.
Username and Password applicability
The same username and password are used for maintenance port command line
access, telnet access and FTP access.
Planning, Installation and Administration Guide
26