Addendum To Ntp 241-9501-301 Vector Management Interface; User Guide; Resetting The Network Module; Changes To Ntp 241-9501- 501 Vector Switch Hardware Maintenance Guide - Nortel V2 Release Note

20

Addendum to NTP 241-9501-301 Vector Management Interface

User Guide

Resetting the Network Module

Changes to NTP 241-9501- 501 Vector Switch Hardware Maintenance
Guide
This section contains the following procedures: selecting a MAC address,
removing an HSI cable and installing an HSI cable.
Magellan Vector 2.0 Release Note, Issue 1.9.1
This section provides information for a new feature that is not documented
in NTP 241-9501-301, Vector Management Interface User Guide,
Chapter 11, "VMI operation commands," page 293.
Vector 2.0.8 and higher supports the ability to reset a network module.
Caution: Invoking this command causes service disruptions to all ports on
the affected netmod.
To reset the network module, enter the command netmod reset at the level
operation:
operation netmod reset <module>
where:
is the link module (A to D) you want to reset.
module
For example:
localhost::> operation netmod reset B
resets and initializes netmod B.
Once the command is invoked, VMI displays the following message:
Resetting the network module will destroy all
existing connections which are already
configured on the network module.
Reset Network Module
Enter y (yes) to reset the network module or enter n (no) or press
<Return> to cancel the reset. The default is no.
- B - [n]?