Cisco Catalyst 3560X-24P Command Reference Manual page 622

Cisco ios release 12.2(55)se

Hide thumbs Also See for Catalyst 3560X-24P:

Table of Contents

show interfaces

This is an example of output from the show interfaces command for an interface on stack member 3:

Switch# show interfaces gigabitethernet3/0/2

GigabitEthernet3/0/2 is down, line protocol is down

Hardware is Gigabit Ethernet, address is 0009.43a7.d085 (bia 0009.43a7.d085)

MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Auto-duplex, Auto-speed

input flow-control is off, output flow-control is off

ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output never, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue :0/40 (size/max)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

This is an example of output from the show interfaces accounting command.

Switch# show interfaces accounting

Interface Vlan2 is disabled

No traffic sent or received on this interface.

No traffic sent or received on this interface.

GigabitEthernet1/0/1

Catalyst 3750-X and 3560-X Switch Command Reference

reliability 255/255, txload 1/255, rxload 1/255

2 packets input, 1040 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 0 multicast, 0 pause input

0 input packets with dribble condition detected

4 packets output, 1040 bytes, 0 underruns

0 output errors, 0 collisions, 3 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier, 0 PAUSE output

0 output buffer failures, 0 output buffers swapped out

Spanning Tree

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands